Easton Emergency LocksmithMobile locksmith, Easton, PA
Ignition repair in Easton, PA
Key stuck, key will not turn, key spins and nothing happens. We sort out whether it is the key, the cylinder or something a mechanic should see, and we fix the first two at your car.
Describe the symptom and we will know where to start
Each of these points to a different cause. Tell the dispatcher exactly which one you have.
- Key goes in but will not turn at all
- Key turns only after wiggling or forcing
- Key will not come out of the ignition
- Key turns freely with no resistance and no start
- Key goes in only partway
- Steering wheel locked and the key will not budge
If the dash lights come on and the key turns normally, it is probably not the ignition cylinder. We will say so on the call instead of sending a van.
What we do about it
The key is checked first, because a worn or bent key causes a surprising share of ignition complaints and a freshly cut key is the cheapest fix there is. If the key is good, the cylinder is worn or jammed. We repair in place when we can, and otherwise fit a new cylinder keyed to the key you already use for the doors, so you do not end up with two keys for one car. On newer cars the transponder side is programmed to match.
Steering column access varies by make. Some cylinders release in minutes; some mean the column shroud and a few fasteners come off first. The pricing structure for your car's setup is explained before any of that starts.
What not to do while you wait
Do not force the key. Do not spray anything into the keyway except a dry lock lubricant. Do not try to pull a stuck key with pliers, because a snapped blade in an ignition is a bigger job than a stuck one. Make sure the car is in park and try gentle pressure on the wheel to release the steering lock, and if that does not do it, call.
Lighten the keyring once this is fixed. A pound of keys and keychains levering on the cylinder every day is what wore it out.

Ignition questions
Can the new cylinder use my old key?
That is the goal, and it is possible on most cars. If not, we rekey the doors to the new key so one key runs the car.
Push-button car will not recognize the fob.
There is no keyed ignition on those. It is a fob or programming problem, and we handle that at the car as well.
Is this a locksmith job or a mechanic job?
Key and cylinder: locksmith. Switch, wiring or starter: mechanic. We tell you honestly which you have after checking the key and cylinder.
Related services
Ignition acting up?
Call 484 891 1922 and describe exactly what the key does.